Assembly Instructions For Re-Usable 600 Series (PTFE Smooth Bore) Hose and Fitting

Note: Lubricate threads with duck oil before assembly (or a similar commercial lubricant may be used). Goodridge recommend that the
finished assembly is fully pressure tested prior to use.

Step 1	Step 2	Step 3	Step 4
Using a fine tooth saw blade or cut off wheel, cut hose to the required length. Clean any loose debris from both the cut ends and inside the hose. Note: Lubricate threads with Duck Oil before assembly. (or a similar commercial lubricant may be used)	Main fitting body - Olive - Socket On a clean flat surface disassemble the fitting, this consists of 3 parts, the Main fitting body, Olive and Socket.	Push two sockets back to back over the overbraid working from the non flared end	Using an appropriate sized Goodridge mandrel, flare out both ends of the stainless steel overbraid from the PTFE inner tube

Step 1

Step 1 - Reusable 600 Series

Step 2

Step 2 - Reusable 600 Series

Step 3

Step 3 - Reusable 600 Series

Step 4

Step 4 - Reusable 600 Series

Using a fine tooth saw blade or cut off wheel, cut hose to the required length. Clean any loose debris from both the cut ends and inside the hose. Note: Lubricate threads with Duck Oil before assembly. (or a similar commercial lubricant may be used)

Main fitting body - Olive - Socket

On a clean flat surface disassemble the fitting, this consists of 3 parts, the Main fitting body, Olive and Socket.

Push two sockets back to back over the overbraid working from the non flared end

Using an appropriate sized
Goodridge mandrel, flare out both ends of the stainless steel overbraid from the PTFE inner tube

Step 5	Step 6	Step 7
Push an olive onto each end of the PTFE inner tube under the stainless steel over braid by hand and finish off by pushing against a flat solid surface making sure the PTFE tube is fully home in the olive.	Holding the main fitting body in a smooth jaw vice, lubricate the thread and push the hose over the nipple end and start to thread the socket onto the fitting by hand.	Finish tightening the socket onto the fitting with a good quality spanner until the socket is one full turn from the main fitting hex. PRESSURE TEST	UNDER NO CIRCUMSTANCES SHOULD THE SOCKET BE LOOSENED IN AN ATTEMPT TO ADJUST THE ALIGNMENT AFTER ASSEMBLY

Step 5

Step 5 - Reusable 600 Series

Step 6

Step 6 - Reusable 600 Series

Step 7

Step 7 - Reusable 600 Series

Push an olive onto each end of the PTFE inner tube under the stainless steel over braid by hand and finish off by pushing against a flat solid surface making sure the PTFE tube is fully home in the olive.

Holding the main fitting body in a smooth jaw vice, lubricate the thread and push the hose over the nipple end and start to thread the socket onto the fitting by hand.

Finish tightening the socket onto the fitting with a good quality
spanner until the socket is one
full turn from the main fitting hex.

PRESSURE TEST

UNDER NO CIRCUMSTANCES SHOULD THE SOCKET BE
LOOSENED IN AN ATTEMPT TO ADJUST THE ALIGNMENT AFTER ASSEMBLY

Tip: Submerge the end of the hose in hot water to soften and ease assembly.